Table of Contents
Equipment at ATM
About
In ATM there is various equipment available for use for all members. Some machines might need introduction before use. Those machines will be marked with the either blue or yellow banner indicating if introduction is recommended or needed.
This article will be split up into groups of tools to make it easier for people to navigate. Larger tools then have their own sub-articles, while the smaller tools might be joined into sections of a single sub-article.
Important! This article does not list every tool available at ATM. This article is subject to change and the information might not be up to date!
Wood workshop
Here below in multiple subsections, some of the tools available for use in the wood workshop are listed.
Suction system
The heart and soul of the wood workshop is the dust collector system, also called suction system. This system comes in three parts. The high volume (big) suction system, the high vacuum (small) suction system, and the air purifier system.
Do not use any power tools in the wood workshop without having either the high volume or high vacuum suction systems connected to the machine and active.
Disc sander
Disc sander (JET JDS12) is a 300mm disc sander to be used for wood.
This tool needs to be connected to the suction system whenever in use.
Bandsaw
!This tool needs introduction before usage!
The Hammer N4400 is a bandsaw with up to 310mm cutting height to cut wood.
This tool needs to be connected to the suction system whenever in use.
Lathe
!This tool needs introduction before usage!
The ONEWAY 1640 Lathe is a lathe with up to 40“ (101.6 cm) Distance between Centers (cut length) and 16” (40.64 cm) Swing over Bed (cut diameter). This lathe should only be used to turn wood.
This tool needs to be connected to the suction system whenever in use.